HT instruments HT4016 - Manual (Page 19)

HT4014-HT4016
EN - 18
5. MAINTENANCE
5.1. GENERAL INFORMATION
1. This digital clamp meter is a precision instrument. Whether in use or in storage, please
do not exceed the specifications to avoid any possible damage or danger during use.
2. Do not place this meter in high temperature and/or humidity or expose to direct
sunlight.
3. Be sure to turn the meter off after use. For long term storage, remove the batteries to
avoid leakage of battery fluid that can damage the internal components.
5.2. BATTERY REPLACEMENT
When LCD displays the symbol " " replace battery.
WARNING
Only experts and trained technicians should perform this operation. Remove
the test leads or the conductor under test before replacing the batteries.
1. Set range switch to OFF position.
2. Remove the test leads or the objects to be tested.
3. Remove the screw from the battery cover, and detach the battery covers from the
bottom cover.
4. Remove the low batteries.
5. Replace them with new of then same type (1.5V LR 03 AAA).
6. Replace the battery cover and screw.
7. Use the appropriate battery disposal methods for your area.
5.3. CLEANING
For cleaning the instrument use a soft dry cloth. Never use a wet cloth, solvents or water,
etc.
5.4. END OF LIFE
CAUTION: this symbol indicates that equipment and its accessories shall be
subject to a separate collection and correct disposal.