beautypg.com

Pro-Cut PFM 9.0 User Manual

Page 39

background image

WWW.PROCUTUSA.COM

PG /

Ø39

DRO DIAGNOSTICS

CONTINUED

Press the START button again and the word "5 Adj." screen will be displayed. Press the START button once more and the
last five adjustment cycle times will be displayed in seconds. Press the START button once more and you will reach the
units display toggle. Pressing 'Start' will toggle between inch and metric (mm for thickness and microns for runout) display
modes. Press the START button one more time to enter Thickness Calibration mode. This is for G2X equipped lathes. Further
information is found on page 50.

This value represents the average compensation
time recorded in seconds over the life of the lathe.

Display of average compensation time of the last 5
successful compensation cycles.