IEI Integration uIBX-200-VX800 v2.10 - Manual (Page 84)

uIBX-200-R21/VX800 Embedded System
Page 74
Step 3: The recovery tool setup menu is shown as below.
Figure A-3: Recovery Tool Setup Menu
Step 4: Press <5> then .
Figure A-4: Command Mode
Step 5: The command prompt window appears. Type the following commands (marked
in red) to create two partitions. One is for the OS installation; the other is for
saving recovery files and images which will be an invisible partition.
(Press after entering each line below)
system32> diskpart
DISKPART> list vol
DISKPART> sel disk 0
DISKPART> create part pri size= ___
DISKPART> assign letter=N
DISKPART> create part pri size= ___
DISKPART> assign letter=F
DISKPART> exit
system32> format N: /fs:ntfs /q /y