Power panel features, Power panel electrical/light testing procedures, 7 round pin trailer tester – IPA Tools 9007A Smart MUTT Head User Manual
Page 11

11
POWER PANEL FEATURES
K. 12V DC BATTERY TRICKLE CHARGE INPUT (Fig. 3)
Use for connection of trickle charger to battery. Allows float charge to be kept on bat-
tery when unit is not in use.
L. MUTE SWITCH (Fig. 3)
Flip switch up to mute alerts.
M. 30 AMP FUSE SOCKET (Fig. 3)
Overload protection.
N. CHASSIS GROUND OUTLET (Fig. 3)
Insert supplied ground cable into this socket for trailers using the frame or body for
ground connection instead of ground pin in harness.
POWER PANEL
ELECTRICAL/LIGHT TESTING PROCEDURES
7 ROUND PIN TRAILER TESTER
MANUAL MODE
To avoid false readings, visually inspect trailer socket for corroded and/or
squeezed pins.
Bad or broken socket pins can cause false readings. (Replace socket if pins are
broken or socket appears to have been subjected to extreme heat. Clean all
connections and load socket with dielectric grease).
1. Prior to any MUTT
®
testing, connect the 7 pin connector or you will receive
erroneous readings. The MUTT
®
is intended to be used while connected to a
trailer or while cable testing.
2. Secure battery connections to tester.
3. Make sure the Remote Key Fob has been programmed. (pg. 15)
4. Insert the provided 7 round cable to the socket on the right side of the tester.
5. Before testing trailer lights, test the 7 pin cable with the socket on the left side
of the MUTT® (cable tester).
Fig. 3 – Power Panel
K
L
M
N