SAMPI VP-Series Pneumatic Valves - Manual

The pneumatic valves can be used to intercept
hydrocarbons such as diesel, gasoline, kerosene,
airplane fuel products and various solvents with the
exception of special versions requested by clients for
the specific use.
In standby (no low flow and high flow air supply) the
shutter, attached to the shaft, presses on gasket
thanks to the action of a spring preventing the “IN”-
“OUT” passage. Once closed, the action of the spring is
reinforced by the force due to the differential section
defined by the construction diameters of the shutter
and its inner guide (not shown in the figure) which
contributes to the “seal” of the valve.
VP-Series Pneumatic Valves
Specifications Sheet
Operating states
 Full flow opening
 Reduced flow opening
 Change from full flow to reduced flow
 Change from full flow to zero flow
 Change from reduced flow to zero flow
Materials
Part Material
Body Aluminium
Cover Aluminium
Shutter Aluminium
Guide Aluminium
Drive parts Aluminium
Shafts Stainless steel AISI 316
Springs Stainless steel AISI 302
Gaskets Viton, Teflon
screws Carbon steel, stainless steel