SAMPI Stationary Gravity Meter for discharge control - Manual

Stationary Gravity Meter for discharge control
skid is designed for on ground installation with
gravity delivery system, namely for gravitational
fall of the product from transported tank to
storage tank. The skid is equipped with a gravity
meter associated an Electronic Register TE550
with operator interface. The system is made of
materials that make it suited for outdoor
installation. It is designed to ensure top
performance and guarantee the safety of
people, product and environment, analyzing all
critical aspects, foreseen and foreseeable, for its
entire life cycle, from installation to disposal.
Stationary Gravity Meter for discharge control
Specifications Sheet
Features
Pressure
Operating
Temperature
Power Supply
Compressed Air Minimum
Operating Pressure
Bar (PSI) °C (°F) Bar (PSI)
Up to 0,5 (7,25)
-20 to 70
(-4 to 158)
230V / 50 Hz 2,5 (38,26)
On the skid is installed a compressed air reservoir (capacity 15
lt.), charged to 10 bar (145 PSI).
The reservoir has the purpose to supply compressed air to the
pneumatic actuator of the flow control valve.
Minimum operating pressure of the control valve is 2,5 bar
(38 PSI).
The compressing air cylinder has arrange of about 300 cycles
(cycle: open/close low flow/close).
SAMPI spa
A unit of IDEX Corporation
Via Amerigo Vespucci, 1
55011 Altopascio (Lucca) – Italy
Phone: +39 0583 24751
Fax: +39 0583 264748
www.sampi.it
The Stationary Gravity Meter for discharge control skid is composed by:
 Gravity Meter
 Automatic Air Eliminator
 N° 2 LC Sound Air Sensor
 Temperature Probe
 TE550 Flow Computer
 LKI Operator Interface
 Compressed Air Tank