General Pump KEZ Owner Manual v.2 - Manual (Page 4)

Page 4
GENERAL PUMP
A member of the Interpump Group
KEZ SERIES
2. SYMBOL DESCRIPTIONS
Warning
Potential Danger
Danger
High Voltage
Danger
Wear protective mask
Danger
Wear goggles
Danger
Wear protective gloves
Danger
Wear protective boots
Read carefully and understand
the manual before operating
the pump
1. INTRODUCTION
This manual describes the use and maintenance
instructions of the KEZ pump, and should be carefully read
and understood before using the pump.
Correct use and adequate maintenance will guarantee the
pumps trouble-free operation for a long time. General
Pump declines any responsibility for damage caused by
misuse or the non-observance of the instructions indicated
in this manual.
Upon receiving the pump, check that it is complete and in
perfect condition.. Should anything be found out of order,
please contact us before installing and starting the pump.
3. SAFETY
3.1 General Safety Indications
The misuse of pumps and high pressure units may cause
severe injury to people and/or damage to property. Anyone
requested to assemble or use high pressure units must
possess the necessary competence to do so, should be
aware of the characteristics of the components assem-
bled/used, and must adopt all the necessary precautions
in orter to guarantee maximum safety in any operating
condition. In the interest of safety, no precaution that is
reasonably feasible must be neglected, both by the
Manufacturer and the Operator.
3.2 High pressure unit safety requirements
1. The pressure line must always be equipped with a
safety valve.
2. High pressure unit components, in particular
for those units working outside, must be adequately
protected against rain, frost and heat.
3. The units electrical parts must be adequately
protected from water spray, and must comply with the
specific norms in force.
4. High pressure hoses must be correctly sized for the
units maximum operating pressure, and must only be
used within the pressure range indicated by the hose
manufacturer.
5. The extremeties of high pressure hoses must be
sheathed and fastened to a steady structure in order
to avoid dangerous whiplashes should they burst or
should their connections break.
6. Appropriate safety guards must be provided for the
pump transmission systems (joints, pulleys and belts,
auxiliary drives).
3.3 Safety During Operation
The working area of a high pressure system muste be
clearly signalled. Access must be prohibited to non-author-
ized personnel and, if possible, the area must be fenced
in. The personnel authorized to access this area must be
previously trained, and informed about the risks that may
arise from failures or malfunctions of the high pressure
unit.
Before starting the unit, the operator must check:
1. That the high pressure unit is correctly fed (see
paragraph 9.5).
Ref 300665 Rev.C
07-13