PROLiNK PIC1007WP User Manual - Manual (Page 19)

1.13. Email/Ftp Alarm
The IP Camera provides the Email function that will send out an email with a jpeg picture attached when
there is an event trigger. Alternatively, it can also send captured jpeg picture to a ftp server. You can enable
or schedule the Email/ftp function in this page:
1. Email/FTP trigger – choose between “Motion”, “Schedule” and “Disable”
a) If “Motion” is selected, it means that when there is a motion detected, the system will send out the
email and/or ftp with the captured video snapshot.
b) If “PIR” is selected, it means that when there is a PIR alarm detected, the system will send
out the email and/or ftp with the captured video snapshot. If the PIR alarm is constantly on, the IP
Camera will keep sending out email/ftp message every second for up to 30 seconds.
c) If “Schedule” is selected, it means that the email/ftp alarm detection and triggering will be scheduled
by the “scheduling” in section 1.18.
d) ”Disable” will disable the email/ftp alarm.
2. Motion sensitivity – Range from 1 (high) ~ 5 (medium) ~ 10 (low).
“High” means high sensitivity, i.e., the motion detection is triggered by a very small movement in the
video image. If “High” is selected and the size of the moving object is larger than about 1% of the
whole video area, it is detected. Please be noticed that the real size of the object could be large or
small, anyway, the detection is only based on the relative size of the object. Probably a small pencil
moving near the IP Camera could be detected, but a moving car far away from the IP Camera could not
be detected.
“Low” means low sensitivity, i.e., the motion detection is triggered by a very large movement. If the size
of the moving object is larger than about 10% of the whole video area, it is detected. “Medium” means
3% to trigger the detection.
3. Send email message – if this item is enabled, the IP Camera will send out an email message with the jpeg
picture attached to the specified email account.
4. Email recipient – this is the email address to receive the detection notice message. An email message with
the jpeg picture file named by the date/time of the triggered moment will reach this address.
5. Send FTP message – if this item is enabled, the IP Camera will send out a jpeg picture file to the specified
ftp account.
6. FTP server – this is the FTP server address to receive the jpeg file.
7. FTP username/password – this is the username/password to login into the FTP server, so, this triggered
jpeg file will be allowed to reach this FTP server.
8. Remote folder – the jpeg file will be put under this folder of the FTP server.
When this modification is “Save & Apply”-ed, it works immediately, but all the connected video viewing users
will be disconnected.
The default setting is “Disable”.
Figure 3-14: Email/FTP Alarm page
EN 19