Advantech EKI-7657C - Manual (Page 79)

69 Chapter3
• Pull down the selection item and focus on 802.1Q then press Apply to set the VLAN Operation
Mode in 802.1Q mode.
• Enable GVRP Protocol: Tick the checkbox to enable GVRP protocol. This checkbox is available while
the VLAN Operation Mode is in 802.1Q mode.
• Management VLAN ID: The default value is ‘0’ which means VLAN function in 802.1Q mode is not
available. While this column field is filled with a value from 1 to 4096, the member ports of this VLAN
can access the management interface.
• Select the port you want to configure.
• Link Type: there are 3 types of link type.
¾ Access Link: Single switch only, it allows the user to group ports by assigning the same
Untagged VID. While this link type is set, the Untagged VID column field is available but the
Tagged VID column field is disabled.
¾ Trunk Link: The extended application of Access Link. It allows the tagged frames go across
two or more switches by assigning the tag with VID to the frames. Having set this link type, the
Tagged VID column field is available but the Untagged VID column field is disabled.
¾ Hybrid Link: Both Access Link and Trunk Link are available.
• Untagged VID: Assign the untagged frame VID.
• Tagged VID: Assign the tagged frame VID.
• Click
to have the settings taken effect.
Figure 3.37: 802.1Q VLAN Configuration
Group Configuration
Edit the existing VLAN Group.
• Select the VLAN group in the table list.