PERKO 0911 User Manual
PERKO Hardware
FIG. NO. 0911
REFLECTOR REPLACEMENT KIT
FOR USE WITH 1900 SERIES PERKO SEARCHLIGHTS
This kit is necessary when replacing the reflector in an older series Perko searchlight.
This kit contains:
8- Reflector Clip Assemblies, each consisting of a long and short clip.
Proceed As Follows:
(1)
Remove the rear cover, saving the screws that hold the cover in place.
(2)
Remove and discard the old reflector clips, spacer plates, and reflector, but keep
the screws, nuts and lock washers for step (3).
(3)
Using the old screws, lock washers and nuts, secure three of the four new
reflector clip assemblies into place.
(4)
Slide the new reflector into place, then insert and secure the last reflector clip
assembly.
(5)
Replace rear cover, and secure with the old screws.
PERKO, INC.
16490 N.W. 13th Ave.
Miami, FL 33169-5718
03/06
0911INS1
- 8501 (1 page)
- 9601 (1 page)
- 8603 (1 page)
- 9703 (1 page)
- 8511 (1 page)
- 9612 (1 page)
- 0584F (1 page)
- 0485 (1 page)
- 0588F (1 page)
- 1418 (1 page)
- 0630 (1 page)
- 0584T (1 page)
- 0584S (2 pages)
- 0588T (1 page)
- 0588S (1 page)
- 0586F (1 page)
- 0586T (1 page)
- 0586S0A (1 page)
- 0586S0P (1 page)
- 1419 (1 page)
- 0640 (1 page)
- 0577 (1 page)
- 1324 (1 page)
- 0525 (1 page)
- 0540 (1 page)
- 0561 (1 page)
- 1319 (1 page)
- 0597 (1 page)
- 0570 (1 page)
- 0579 (1 page)
- 1318 (1 page)
- 0571 (1 page)
- 0598 (1 page)
- 0929 (1 page)
- 0931 (2 pages)
- 1091 (2 pages)
- 1082 (2 pages)
- 0711 (2 pages)
- 0706 (2 pages)
- 0927 (2 pages)
- 0675 (1 page)
- 0960 (2 pages)
- 0928 (2 pages)
- 1280 (2 pages)
- 1089 (2 pages)