PERKO 0584T User Manual
Carb
NPTF Dry Seal Threaded Valves for use
on Aluminum Tanks for EPA Compliant Fuel Systems
INSTALLATION INSTRUCTIONS
PLEASE READ ALL INSTRUCTIONS BEFORE PROCEEDING
These valves are for use on fuel tanks to comply with the new CARB and EPA
standards and meet the requirements of U.S.C.G. Safety Standards (July 31,
2011) for 40 CFR Parts 9, 60, 80 et al. (Control of Diurnal Emissions From
Nonroad Spark-Ignition Engines and Equipment).
Note: Inspect valve fitting annually for corrosion, replace if necessary.
Series 0584T Inlet Check Valves (ICV)
1.
These valves are designed to mount into 1-1/2”
NPTF dry seal aluminum threaded receivers welded onto tanks
(receiver not supplied).
2. Thread valve into receiver. For angled fittings, orient hose barb in the
direction of the fill fitting. Do not use the hose barb as a lever to tighten
valve.
3. Attach 1-1/2” fill hose onto hose barb and tighten using hose clamps
in accordance with ABYC Fuel System Fill Hose Clamping Standards
(H24 Table 3).
PERKO, INC.
16490 N.W. 13th Avenue
Miami, FL 33169-5707
www.perko.com
10/12
0584INS1
*The above referenced standards can be obtained from:
(1). American Boat & Yacht Council, Inc. (2) U.S. Coast Guard
(3). E.P.A.
613 Third Street, Suite 10
Washington, D.C. 20593
401 “M” Street S.W.
Annapolis, MD 21403
(or your local C.G. office)
Washington, D.C. 20460
CARB
&
0584T00
NPTF Dry Seal Threaded Valves for use
on Aluminum Tanks for EPA Compliant Fuel Systems
INSTALLATION INSTRUCTIONS
PLEASE READ ALL INSTRUCTIONS BEFORE PROCEEDING
These valves are for use on fuel tanks to comply with the new CARB and EPA
standards and meet the requirements of U.S.C.G. Safety Standards (July 31,
2011) for 40 CFR Parts 9, 60, 80 et al. (Control of Diurnal Emissions From
Nonroad Spark-Ignition Engines and Equipment).
Note: Inspect valve fitting annually for corrosion, replace if necessary.
Series 0584T Inlet Check Valves (ICV)
1.
These valves are designed to mount into 1-1/2”
NPTF dry seal aluminum threaded receivers welded onto tanks
(receiver not supplied).
2. Thread valve into receiver. For angled fittings, orient hose barb in the
direction of the fill fitting. Do not use the hose barb as a lever to tighten
valve.
3. Attach 1-1/2” fill hose onto hose barb and tighten using hose clamps
in accordance with ABYC Fuel System Fill Hose Clamping Standards
(H24 Table 3).
PERKO, INC.
16490 N.W. 13th Avenue
Miami, FL 33169-5707
www.perko.com
10/12
0584INS1
*The above referenced standards can be obtained from:
(1). American Boat & Yacht Council, Inc. (2) U.S. Coast Guard
(3). E.P.A.
613 Third Street, Suite 10
Washington, D.C. 20593
401 “M” Street S.W.
Annapolis, MD 21403
(or your local C.G. office)
Washington, D.C. 20460
CARB
&
0584T00