Luminex 100 User Manual Version 1.7 - Manual (Page 21)

x MAP Technology Safety
PN 89-00002-00-063 Rev. A 2 - 5
This voltage label displays on the back of the Luminex XYP:
Figure 2-6. Luminex XYP Voltage Label
Fluidics
The Luminex 100 analyzer contains fluidics. In the event of a fluid
leak, turn off all power to the system and disconnect all power cords.
Remember that the on/off switch is not a disconnect means - the
power cord must be removed from the outlet. Contact Luminex
Corporation for further information.
You must manually monitor waste levels. Do not allow the waste
container to overflow. Empty the waste container each time you fill
the sheath fluid container. Do not place the waste container on top of
the analyzer.
United States and international regulations require the following
warnings to appear on the analyzer during operation and
maintenance.
This label appears on the back panel of the analyzer:
Figure 2-7. Laser Class Label
Warning: If the system is used
to test biological samples, use
your standard laboratory safety
practices when handling system
waste.