IQinVision Alliance & Sentinel Series Pole Mount Adaptor - Manual (Page 6)

6
9. Pull the cutting handle near the tool nose
to cut the strap as shown in Figure 4.
10. Remove tensioning tool, holding the stub
of the strap down with thumb as shown
in
Figure 5.
11. Remove thumb and using a hammer,
knock the strap stub flat against the
buckle, and then hammer down the two
buckle ears over the strap stub as shown
in
Figure 6.
Figure 4
4. Attaching Camera Body/Junction Box
a. Attach Alliance with Outdoor Back Box and Wall
Mount Kit
i. Follow the instructions included with the Alliance Series cameras, and
Outdoor Back Box and Wall Mount Kit to complete the installation.
b. Attach Sentinel Camera Body to Sentinel Junction
Box
i. Follow the instructions included with the Sentinel 8xx Series camera system
to complete the installation.
Figure 5
Figure 6