IQinVision Alliance & Sentinel Series Pole Mount Adaptor - Manual (Page 5)

1. Ensure one end of the strap is inserted into
the buckle.
2. Wrap strap around the pole and through the
slots on the Pole Mount Adapter, and bring
the end back through the buckle.
3. If possible, wrap the strap a second time
around the pole, through the Pole Mount
Adapter slots and through the buckle again.
4. Place leading end of strap in through
the tensioning tool nose and move the
nose up as close to the buckle as possible
as shown in
Figure 1. This will ensure
that the buckle does not slide into the
tool nose during tensioning.
5. Make sure the leading edge is securely
clamped into the tensioning mechanism as
shown in
Figure 1.
6. Apply tension by turning the handle.
7. When tight, place finger on BANDIT ® strap
at the bridge of the buckle as shown in
Figure 2 while continuing to slowly turn
the tool handle. When the strap stops moving
through the buckle, it is at maximum
tension.
8. As shown in Figure 3, roll the tool over the
buckle, backing off with the tension handle
throughout the entire rolling operation.
Failure to back off with the tension handle
may result in the strap breaking. Only back
off the tension tool enough to allow the strap
to bend around the buckle.
5
Figure 1
Figure 3
Figure 2