IQinVision Alliance & Sentinel Series Pole Mount Adaptor - Manual (Page 4)

4
iv. Make any cable connections and snap the Alliance camera module into the
Alliance Outdoor Back Box, and attached the supplied bubble.
b. Attach Sentinel Junction Box to Pole Mount Adapter
NOTE: If using the rear weather fittings of the Sentinel Junction Box, please
follow step ‘i.’ If using the ½” conduit opening on the bottom of the Sentinel
Junction Box, skip to step ‘iii.’
i. Thread the Ethernet cable and any other secondary cabling through the
center hole in the Pole Mount Adapter and through either or both of the rear
weather fittings on the Sentinel Junction Box, making sure to pull enough
cabling through to be able to work with later in the installation.
ii. Tighten the rear weather fittings to secure the cable(s).
iii. Line up the four mounting holes on the rear of the Sentinel Junction Box
with the corresponding holes on the face of the Pole Mount Adapter. Using
the 5mm Allen wrench secure the 4 included 1-inch M6 Allen head screws
through the mount holes in the Sentinel Junction box to the threaded
receivers on the Pole Mount Adapter. Thread supplied spring lock washers
onto the 1-inch M6 Allen head screws.
3. Attaching Adapter to Pole
NOTE: Visually inspect the pole to be used for loose or deteriorated materials
and either repair this area or choose an area of the pole that is free from such
defects.
a. Thread the tensioning straps so that each of the two straps passes through one
pair of slots and around the pole. On poles that are 7 inches (178 mm) or less
in diameter, it is recommended that the straps be double wrapped around the
pole and through the slots before tensioning and securing.
b. Once the desired height of the Pole Mount Adapter is achieved, tighten the
straps down using a tensioning tool (not included) to the desired or specified
tension using the following instructions: