IQinVision Alliance Series Wall Mount - Manual (Page 5)

C. If desired, attach the supplied tether to the Dome
Bubble / Trim Ring assembly.
D. After adjusting camera position, field of view and focus,
attach the Dome Bubble/ Trim Ring assembly to the
Adapter Box by tightening the four (4) Torx screws
that are captively held in the Dome Bubble / Trim
Ring assembly (Figure 5.1). Refer to the Alliance-pro
Installation and Operating Instructions for additional
details.
Alliance-mx
A. Make any cabling connections between the wall side
and the Alliance-mx camera.
B. Rotate the black shroud inside the dome trim ring
cover so it aligns with the camera position.
C. Place the supplied desiccant pack inside the dome
to prevent fogging due to moisture that is present
when installing the camera. Use the supplied cable
tie to keep the desiccant from falling down into the
dome bubble. Refer to the Alliance-mx Installation and
Operating Instructions for additional details.
D. Attach the dome trim ring cover with shroud to the
enclosure by tightening the three tamper-proof
screws with the supplied Torx T-20 security wrench
(Figure 5.2).
5
Figure 5.2
Figure 5.1