IQinVision Alliance Series Wall Mount - Manual (Page 4)

4
c. Feed the cabling through the wall arm and hang the
wall arm on the Back Box hangers (Figure 4.2).
d.
Feed the cables into the Adapter Box through the rubber
Heyco hole plug on the rear of the box.
C. Attaching the Adapter Box to the Wall Arm:
a. Reattach the Adapter Box to the Wall Arm using the same (4) screws removed
during disassembly.
b. Go to the “Connecting the Camera and Finalizing Installation” section of this
installation guide.
Alliance-mx Wall Mount Installation
A. The Alliance Wall Mount is designed for installation indoors or outdoors. Begin by
disassembling the Wall Mount into 2 pieces (See Figure 4.3):
a. Remove Back Box from Wall Mount by removing the (4) screws.
B. Mounting the Back Box to a masonry or other durable wall surface:
a.
Follow common mounting practices required to safely mount the Alliance Wall
Mount to the intended surface.
b.
Pull any cabling from the wall side through the Back Box and mount the Back
Box to the wall surface using the supplied or equivalent hardw are.
c. Feed the cabling through the wall arm and hang the
wall arm on the Back Box hangers (Figure 4.4).
d. Go to the “Connecting the Camera and Finalizing
Installation” section of this installation guide.
5 Connecting the Camera and Finalizing Installation
Alliance-pro
A. Make any cabling connections between the wall side and the Alliance-pro camera.
B. Snap the Alliance-pro camera module into the Alliance Adapter Box by lining up any
one of the three (3) mounting tabs into the retaining channel and then snapping
the remaining two tabs in. Be sure to properly service loop the cabling for proper
fit and retained cable connectivity.
Figure 4.3
Figure 4.2
Wall Arm Back Box
Figure 4.4