IQinVision IQA-CNR - Manual (Page 4)

3. Make sure the leading edge is securely clamped
into the tensioning mechanism.
4. Apply tension by turning the handle.
5. When tight, place finger on BANDIT® strap at the
bridge of the buckle while continuing to slowly
turn the tool handle. When the strap stops moving
through the buckle, it is at maximum tension.
6. Roll the tool over the buckle, backing off with
the tension handle throughout the entire rolling
operation. Failure to back off with the tension
handle may result in the strap breaking. Only back
off the tension tool enough to allow the strap to
bend around the buckle.
7. Pull the cutting handle near the tool nose to cut
the strap (Figure 2.3).
8. Remove tensioning tool, holding the stub of the
strap down with thumb.
9. Remove thumb and using a hammer, knock
the strap stub flat against the buckle, and then
hammer down the two buckle ears over the strap
stub (Figure 2.4).
C. Go to the “Attaching Alliance or Sentinel Camera to Adapter” section of this
installation guide.
3 Attaching Adapter to Corner
NOTE: Installations should be performed by qualified service personnel only in accordance with local,
state and national code(s).
A. Mounting the Corner and Pole Mount Adapter to an inside corner or outside
corner (see examples below).
1. Pull any cabling from the wall side through the Corner and Pole Mount
Adapter.
2. Mount the Adapter to the interior or exterior corner wall surface using the
appropriate hardware (for outside corner mounting, knockouts must be
removed).
B. Go to the “Attaching Alliance or Sentinel Camera to Adapter” section of this
installation guide.
4
Figure 2.3
Figure 2.4
Inside Corner Outside Corner
Figure 2.2