IQinVision IQA-CNR - Manual (Page 2)

Contents
1 Unpacking 3
2 Attaching Adapter to Pole 3
3 Attaching Adapter to Corner 4
4 Attaching Alliance or Sentinel Camera to Adapter 5
Important Information
This product is intended for use with Alliance-pro and Alliance-mx (with
or without appropriate Wall Mount Kit) and Sentinel Series cameras. It
is not designed for, and will not necessarily be compatible with other
camera systems.
This product is designed for use with the supplied BAND-IT® 0.5
inch (12.7 mm) x 48-inch (1.22 M) metal tensioning straps and a
proper tensioning tool (not included) for proper installation to a pole.
Two recommended tensioning tools are the BAND-IT® C00169 or
Videoalarm’s PM3T.
In order to ensure stability of the camera image, IQinVision recommends
using a pole not less than 4 inches in diameter. Poles with diameters
less than 4 inches may experience frequent and uncontrollable shaking
of the camera in environments with heavy wind or transient vibration,
which will translate into blurred images.
The 48-inch (1.22M) straps included with the Alliance and Sentinel
Corner and Pole Mount Adapter kit can be single wrapped, but they are
designed to be double wrapped for maximum radial compression. If
double wrapped, the straps are effective on poles up to 7 inches (178
mm) in diameter. If single wrapped, the straps will allow mounting of
the Corner and Pole Mount Adapter to poles as wide as 14 inches (356
mm) in diameter. Poles wider than this will require longer straps (not
supplied).