INTELLINET NETWORK 525268 User Manual - Manual (Page 30)

30
SYSTEM & NETWORK SETUP
2.6.1 LAN IP
IP address — Enter the IP address of this router.
Subnet Mask — Enter the subnet mask for this network.
802.1d Spanning Tree — Select “Enable” or “Disable” from the drop-down menu.
The Spanning Tree Protocol (STP) is a network protocol that ensures a loop-
free topology for any bridged Ethernet local area network. The basic function of
STP is to prevent bridge loops and ensuing broadcast radiation. Spanning tree
also allows a network design to include spare (redundant) links to provide
automatic backup paths if an active link fails, without the danger of bridge loops
or the need for manual enabling/disabling of these backup links. In larger
networks, this option should be enabled.
DHCP Server — Select “Enable” or “Disable” from the drop-down menu.
2.6.2 DHCP Server
These settings are only available when “DHCP Server” in the LAN IP section is
enabled, but will also affect wireless clients.
Lease Time — Choose a lease time (the duration that every computer can keep a
specific IP address) for every IP address assigned by this router.
Start IP — Enter the start IP address of the IP range.
End IP — Enter the end IP address of the IP range.
Domain Name— Enter a domain name for your network. (optional)
NOTE: The number of the last field (the “d” field) of “End IP” must be greater than
RECOMMENDED VALUES
IP Address: 192.168.2.1
Subnet Mask: 255.255.255.0
802.1d Spanning Tree: Disabled
DHCP Server: Enabled