beautypg.com

INSTEON Thermostat with Humidity (2441TH) Manual User Manual

Page 18

background image

Page 18 of 28 Rev: 1/21/2014 8:35 AM

Removing a scene from an incoming ON command
1) Press and hold controller’s scene button until controller beeps.

1

Controller’s LED will blink.

2) Press and hold controller’s scene button again until controller beeps again.

Controller’s LED will continue blinking.

3) Press and hold INSTEON Thermostat’s Set button.

INSTEON Thermostat Set LED will blink

green

and unit will beep.

INSTEON Thermostat will double-beep.
LED will return to previous state.
Controller’s LED will stop blinking.

3) Confirm scene removal was successful by tapping the controller scene button you just removed.

INSTEON Thermostat will no longer respond.

Removing a scene from an incoming OFF command
1) Press and hold controller’s scene button until controller beeps.

Controller’s LED will blink.

2) Press and hold controller’s scene button until controller beeps again

Controller’s LED will continue blinking.

3) Simultaneously press and hold INSTEON Thermostat’s Set button and Down arrow.

INSTEON Thermostat

Set

LED

will

blink

green

and

unit will

beep.

INSTEON Thermostat will double-beep.
LED will return to previous state.
Controller’s LED will stop blinking.

4) Confirm scene removal was successful by tapping the controller scene button you just removed.

INSTEON Thermostat will no longer respond.

1

For devices without beepers hold until its LED begins blinking (this may take 10+ seconds)