Gardner Bender KC3540 Knockout Converter - Manual

WARRANTY: GB ELECTRICAL, INC. warrants its
products against defects in workmanship and
materials for 1 year from date of delivery to user.
Chain is not warranted. Warranty does not cover
ordinary wear and tear, abuse, misuse, overloading,
altered products or use of improper fluid. WARRANTY RETURN PROCEDURE: When
question of warranty claim arises, send the unit to the
nearest GB Authorized Service Center for inspection,
transportation prepaid. Furnish evidence of purchase
date. If the claim comes under the terms of our
warranty the Authorized Service Center will REPAIR
OR REPLACE PARTS AFFECTED and return the unit
prepaid. PARTS AND SERVICE: For quality workmanship and
genuine GB ELECTRICAL parts, select an Authorized
GB Service Center for your repair needs. Only
repairs performed by an Authorized Service Center
displaying the official GB Authorized sign are backed
with full factory warranty. Contact GB Electrical
(414) 352-4160 for the name of the nearest GB
Authorized Service Center.
REPAIR AND SERVICE INSTRUCTIONS: For repair service and parts contact your nearest GB ELECTRICAL
Service Center. The Service Center will provide complete and prompt service on all GB ELECTRICAL products.
GB Electrical, Inc.
An Applied Power Company 6101 N. Baker Road, Milwaukee, WI 53209
Phone: (414) 352-4160
FAX (414) 352-2377
RPS-0111 Rev. A 01/07
Gardner
Bender
KC3540
Knockout
Converter
Repair Parts
Sheet
Converter
Punch
KPR7540
Pull Rod
Die
For Punching Holes 3 1 ⁄ 2 ” thru 6”
When using 3 1 ⁄ 2 ” thru 6” punches and dies, thread the KC3540 Converter into the punch from
the inside until seated (see sketch). Be sure the die counterbore is positioned over the boss
projecting from the port end of the cylinder base.
The converter requires a 1 15 ⁄ 16 ” diameter or larger
guide hole (use the 1 1 ⁄ 2 ” knockout).
Do not assemble converter on outer side of punch,
or pull rod will bend during operation.