Gardner Bender BV208D - Manual (Page 4)

RPS-0098 Rev. B 7/07
PO Box 3241 • Milwaukee, WI 53201-3241 • (800) 624-4320 • Fax 414-352-2377
6615 Ordan Drive • Mississauga, Ontario L5T 1X2 • 905-564-5749 • Fax 905-564-0305
WARRANTY: Gardner Bender, INC. warrants its
products against defects in workmanship and
materials for 1 year from date of delivery to user.
Chain is not warranted. Warranty does not cover
ordinary wear and tear, abuse, misuse, overloading,
altered products or use of improper fluid. WARRANTY RETURN PROCEDURE: When
question of warranty claim arises, send the unit to the
nearest GB Authorized Service Center for inspection,
transportation prepaid. Furnish evidence of purchase
date. If the claim comes under the terms of our
warranty the Authorized Service Center will REPAIR
OR REPLACE PARTS AFFECTED and return the unit
prepaid. PARTS AND SERVICE: For quality workmanship and
genuine Gardner Bender parts, select an Authorized
GB Service Center for your repair needs. Only
repairs performed by an Authorized Service Center
displaying the official GB Authorized sign are backed
with full factory warranty. Contact Gardner Bender
(414) 352-4160 for the name of the nearest GB
Authorized Service Center.
REPAIR AND SERVICE INSTRUCTIONS: For repair service and parts contact your nearest Gardner Bender
Service Center. The Service Center will provide complete and prompt service on all Gardner Bender products.
Specifications
BV208DA
Super
Blo-Vac
Vacuum (Inches of Waterlift)
Sealed Vacuum*
110"
Maximum Air Pressure
(Pounds per square inch)*
4
Electrical Rating (Volts-Amps)
120 VAC
13.5A
Type of Motor By-Pass
Number of Impeller Stages 2
Recovery Capacity Gallons) 9**
Net Weight (Pounds) 44
Height with Cart (Inches) 39-3/4
Motor Brush Life (Hours) 750
Bulk Nylon Line
Unlike the Power Saver and Tag-A-
Long packages which dispense a
line as it moves through the conduit
the bulk line package remains at
the conduit entrance and the line is
pulled into the conduit by a line
carrier. The bulk line allows for
longer conduit runs (up to 2200 ft.) and tensile strengths
from 22 to 100 lbs (see Figure 12).
Pull Line
Jet Line stranded PL-series pull
lines are designed specifically for
conduit fishing. These lines are
made of strong polyolefin plastic
that will not rust, rot or mildew.
The patented color coded binder
strand spirals around a bundle of
linear, monofilament that give
almost friction free blowing and
vacuuming. This line, considered
the cadillac of pull line, is
guaranteed to be free of knots
or splices. It is available in
lengths to 6500 ft and tensile
strengths from 100 to 1000
lbs (see Figure 13).
Conduit Measuring Tape
Marked in one foot increments,
this tape is designed to be blown into conduit or duct runs
to determine exact run length for accurate cable cutting
without waste. Available in 3000 ft. rolls (see Figure 14).
Figure 13
PL-Series Pull Line
Figure 12
Bulk Pull Line
Figure 14
Conduit Measuring Tape
Technical Specifications
* Will vary with voltage and atmospheric conditions.
** When using recovery compartment and tool storage compartment
together.
CONDUIT RUN LENGTH (ft.)
Conduit
Size 200 150 300 400 500 600 700 800 900 1000 1100
1/2"
3/4"
1"
1-1/4"
1-1/2"
2"
3"
3-1/2"
4"
5"
6"
2-1/2"
1100 ft. +
BV308D Ultra Blo-Vac
Typical Run with four 90° bends and no obstructions or leaks, using Jet Line
PL232 Pull Line and Foam Line Carrier.