Gardner Bender CS400 Cylinder Support - Manual (Page 2)

WARRANTY: GB ELECTRICAL, INC. warrants its
products against defects in workmanship and
materials for 1 year from date of delivery to user.
Chain is not warranted. Warranty does not cover
ordinary wear and tear, abuse, misuse, overloading,
altered products or use of improper fluid. WARRANTY RETURN PROCEDURE: When question
of warranty claim arises, send the unit to the nearest
GB Authorized Service Center for inspection,
transportation prepaid. Furnish evidence of purchase
date. If the claim comes under the terms of our
warranty the Authorized Service Center will REPAIR
OR REPLACE PARTS AFFECTED and return the unit
prepaid. PARTS AND SERVICE: For quality workmanship and
genuine GB ELECTRICAL parts, select an Authorized
GB Service Center for your repair needs. Only
repairs performed by an Authorized Service Center
displaying the official GB Authorized sign are backed
with full factory warranty. Contact GB Electrical
(414) 352-4160 for the name of the nearest GB
Authorized Service Center.
REPAIR AND SERVICE INSTRUCTIONS: For repair service and parts contact your nearest GB ELECTRICAL
Service Center. The Service Center will provide complete and prompt service on all GB ELECTRICAL products.
GB Electrical, Inc.
An Applied Power Company 6101 N. Baker Road, Milwaukee, WI 53209
Phone: (414) 352-4160
FAX (414) 352-2377
RPS-0130 Rev. A 03/07
4. Fasten the lower frame and stabilizer bar to the
table. Use two 1 ⁄
2
- 13 UNC x 1 3 ⁄
4
” long bolts
installed from the underside of the table. Do not
fully tighten the bolts. Figure 3 & 4.
5. Position the two legs of the cylinder support
under the cylinder end of the table. Align the
holes in the table and fasten the support,
mounting pads and lower frame with two
1 ⁄
2
- 13
UNC x 1 3 ⁄
4
” long hex head bolts.
6. Tighten all four bender-to-frame mounting bolts.
7. Adjust the cylinder support “V” block until the
cylinder is firmly supported and level. Figure 5.
Fig. 3
Fig. 5
Fig. 4