Gardner Bender B2000 Series G-OLD Cyclone Bender - Manual (Page 2)

REPAIR AND SERVICE INSTRUCTIONS: For repair service and parts contact your nearest Gardner Bender
Service Center. The Gardner Bender Service Center will provide complete and prompt service on all
Gardner Bender products.
Gardner
Bender
RPS-0147 06/01
WARRANTY: Gardner Bender warrants its product
against defects in workmanship and materials for 1
year from date of delivery to user. Chain is not
warrantied. Warranty does not cover ordinary wear
and tear, abuse, misuse, overloading, altered
products or use of improper fluid. WARRANTY RETURN PROCEDURE: When
question of warranty claim arises the user should
send his unit to the nearest Gardner Bender
Authorized Service Center for inspection,
transportation to be prepaid and evidence of
purchase date furnished. It the claim comes under the
terms of our warranty the Authorized Service Center
will REPAIR OR REPLACE PARTS AFFECTED and PARTS AND SERVICE: For quality workmanship and
genuine Gardner Bender parts, select an Authorized
GB Service Center for your repair needs. Only repairs
performed by an Authorized Service Center
displaying the official GB Authorized sign are backed
with full factory warranty. Contact Gardner Bender
(414)352-4160 for the name of the nearest GB
Authorized Service Center.
PO Box 3241 • Milwaukee, WI 53201-3241 • 414-352-4160 • Fax 414-352-2377
6615 Ordan Drive • Mississauga, Ontario L5T 1X2 • 905-564-5749 • Fax 905-564-0305
5.0 MAINTENANCE
If motor will not run: Motor could become overheated due
to long repeated usage or severe strain. Allow motor to cool.
To avoid possible injury, always unplug the bender
power cord before attempting maintenance work.
For any repair other than above, contact an authorized GB
Technical Service Center.
6.0 ANGLE ADJUSTMENT
Two different size indicator scales are mounted on the shoe
outer rim. One for 1 ⁄2" thru 2" IMC and Rigid, the other for
EMT 1 ⁄2" thru 2" (Figure 12).
Each size indicator is adjustable to compensate for over long
or short bends which may be due to differences in conduit
characteristics or other variations.
Bends which are too long: Loosen the indicator scale (for
type material being bent) mounting screws. Slide the
indicator clockwise as many degrees as the overbend (if
bend is 5˚ over, move indicator 5˚ clockwise). The degree of
movement is observed by watching one of the size marks as
it moves past the angle disc scale. Tighten the mounting
screws.
Bends which are too short: Loosen the indicator (for type
material being bent) mounting screws. Slide the indicator
counterclockwise as many degrees as the bend is short (if
bend is 5˚ short move counterclockwise 5˚). The degree
movement is observed by watching one of the size marks as
it moves past the angle disc scale. Tighten the mounting
screws.
Note: Two scales one for
rigid and one for IMC
Size Indicator Scale