Biamp A4 - Manual (Page 11)

11. Reset/Initialize each Nexia unit
Because each Nexia unit ships from the factory with a default system configuration, you must
first reset/initialize that unit before loading our own configuration.
File>Network>Perform Nexia Device Maintenance>Reset/Initialize each connected Nexia unit
12. Connect NexLink
For multi-unit systems, “straight-through” Cat-5 cables must be connected from the
appropriate rear panel NexLink TX jack(s) to the appropriate NexLink RX jack(s) according
to the layout of your design. Check the compile results to verify correct NexLink connections.
13. Open layout (.nex) file
File>Open>Select file
14. Enter appropriate Nexia unit serial numbers to equipment table
Tools>Equipment table>Select appropriate serial numbers
Select OK when complete