Biamp LTR User Manual

Page 8

Text mode
Original mode

Connecting to a networked system using two or more Nexia devices

1. Install Nexia software on a Windows

2000/XP Professional PC

PC must have a 10/100baseT NIC.

2. Design and Layout system

Launch Nexia software. Layout signal flow and DSP as desired. Save layout file (.nex).

3. Compile Layout

Compilation results will display number and type of Nexia devices required as well as DSP
power used and NexLink connections between units.

4. Power up Nexia devices

Connect supplied power cord to a grounded AC mains voltage of 100-240VAC @50/60Hz. Connect
other end of power cord to power entrance located on the rear of Nexia unit. Note status of front panel
LED’s. Under normal conditions, all LED’s will remain green once power-up sequence has completed.

This manual is related to the following products:

NEXIA