Biamp LTR - Manual (Page 6)

9. Disconnect PC from Network
File>Network>Disconnect from network
If you do not want to use the default Nexia configuration and wish to load your own custom
configuration, follow steps 1-7 above and then follow below.
10. Reset/Initialize Nexia unit
Because each Nexia unit ships from the factory with a default system configuration, you must
first reset/initialize that unit before loading our own configuration.
File>Network>Perform Nexia Device Maintenance>Reset/Initialize Nexia unit
11. Design and Layout system
Layout signal flow and DSP as desired. Save layout file (.nex).
12. Compile Layout
Compilation results will display number and type of Nexia devices required as well as DSP
power used.