Biamp AudiaFUSION - Manual (Page 4)

3
AudiaFUSION
AudiaFUSION is the newest member of the Audia ® family, bringing together open-architecture DSP, Multi-Channel Amplifier technology,
and device- and load-monitoring capabilities. AudiaFUSION features an 8-channel modular amplifier, 16x16 I/O via CobraNet ® and DSP
with support for channel-to-channel and device-to-device failover. AudiaFUSION can support up to 8 amplifier cards that are individually
software configurable from 100-600 watts for up to 2400 watts of power, with software-selectable 70V, 100V and low impedance outputs
per card. Intuitive software provides audio system design via PC and allows easy selection, viewing and calibration of numerous audio
components: mixers, combiners, matrixes, equalizers, filters, crossovers, dynamics, routers, delays, meters, generators, diagnostic tools,
and more. Once a system design is compiled, it is downloaded into AudiaFUSION, where it can be controlled via AMX,
® Crestron, ® other
third-party control system, or via computer running daVinci™ control software. When installed in a system together, AudiaFLEX and Audia-
FUSION processing resources are allocated as needed, making the whole system more efficient. .
alarm
activity
signal 1
signal 2 status
ais
power
FEATURES
Modular based design •
Amplification modules have software configurable power •
levels/load options
– 8 amplification modules per frame with 100W to 600 Watts
per module (maximum of 2400W per chassis)
– 70 V or 100 V with direct drive capability, or low-impedance
(4 or 8Ω) operation
– Maximum of 2400 watts of power in 3 rack unit device
TCP/IP Network controllable
•
LED Indication: •
– Signal present
– Peak present
– Clip present
– Heat sink temperature fault
– Amplifier failure
– Fan stuck-rotor
Internal amplifier module failover mode
•
Entire device failover mode •
Software Monitoring Features: •
– Peak present
– Heatsink temperature value, warning and fault
– Short circuit on output
– Amplifier failure
– Impedance min/max threshold warning
– Excessive clipping
– Fan stuck-rotor
Seamless integration with CobraNet-enabled Audia systems •
CobraNet Interface (16 channels in/16 channels out) •
CobraNet latency 5-1/3, 2-2/3 or 1-1/3 ms, •
software configurable
Dual Ethernet ports for redundancy
•
Selectable 115/230 volt operation •
Control via RED-1, daVinci or third party control systems •
CE • marked, UL listed and RoHS compliant
Covered by • BIAMP Systems’ five-year warranty