Biamp AudiaFUSION - Manual (Page 10)

9
AudiaFUSION REAR PANEl
Channel-to-Channel Failover
In addition to entire amplifier failover, AudiaFUSION supports channel-to-channel failover, which is triggered by one of the following conditions:
Heat Sink alarm •
Short Circuit alarm* •
Channel Failure alarm •
The wire failover link cable is not required when wiring channel-to-channel failover.
The redundant channel can be wired in parallel to the existing speaker line (shown above) or connected to a redundant speaker line.
The primary amplifier module will resume control after the fault condition is cleared and the unit is re-powered.
OUTPUT Class 2 Wiring
AM-600
OUTPUT Class 2 Wiring
AM-600
1 2
OUTPUT Class 2 Wiring
AM-600
OUTPUT Class 2 Wiring
AM-600
1 2
Primary
Redundant
Redundant Wiring Parallel Wiring
* A Short Circuit alarm will cause failover only if the Persistent Short Circuit Delay time property in the AudiaFUSION is exceeded.