Biamp AudiaFUSION - Manual (Page 11)

10
AudiaFUSION SPECIFICATIONS
AM-600 Card SPECIFICATIONS
Supported Loads: 4 Ω 8Ω, 70-Volt Line, or 100-Volt line direct drive
6 Ω not shown in GUI
Frequency response: 20 Hz – 20 kHz frequency response flat
(+/-1 dB)
Continuous operation:
(in chassis with fans running
normally and unrestricted
intake and exhaust)
400 W: 1 kHz continuous sine wave
indefinitely
600 W: 1 kHz continuous sine wave for at
least 3 minutes
2400 Watt maximum per chassis
Distortion and Noise: ≤0.3% THD+N (20 Hz – 20k Hz) all loads
and power levels
Signal-to-Noise Ratio:
(unweighted over 22 Hz – 20 kHz)
100W
200W
300W
400W
500W
600W
Low-
impedance 70V 100V
>95 dB >100 dB >101 dB
>98 dB >101 dB >102 dB
>99 dB >101 dB >102 dB
>101 dB >102 dB >103 dB
>102 dB >102 dB >103 dB
>102 dB >103 dB >104 dB
Intermodulation
distortion (SMPTE): <0.2%
Inter-channel Isolation: >75 dB (20 Hz-20 kHz, full power out)
DC offset: <10mV
1. In chassis with fans running normally and unrestricted intake and exhaust
AudiaFUSION SPECIFICATIONS
Inputs: 20 bits, 48 kHz, supported CobraNet
latency 5-1/3, 2-2/3 or 1-1/3 ms
software configurable
Overall Dimensions:
Height:
Width:
Depth:
5.25 inches (133mm)
19 inches (483mm)
17.25 inches (438mm)
Connection:
Environment:
Ambient Operating
Temperature Range:
Ambient intake humidity:
Altitude:
RJ45 with shielded Ethernet cable
(CAT5, CAT5e, CAT6, or CAT7)
32-95 degrees F (0 – 35° C)
0 – 100% non-condensing
0 – 10,000 Feet MSL
Weight:
Chassis:
AM-600 card:
50 lbs. (22.68 kg)
1.25 lbs. (0.57 kg)
Compliance: EU Directive 2002/95/EC, RoHS directive
UL listed
CE marked
Power: 110~120 & 220~240 VAC 50/60Hz
switch selectable