Audiovox XMB10 - Manual (Page 7)

128-7546
7 of 16
-7-
1. Turn the Boom Box upside down to access
the battery compartment.
2. Push the battery cover latches forward and flip
up the battery compartment cover to the open
position.
3. Insert eight (8) C-Cell batteries observing
battery polarity as shown; then close the cover.
3. Installing the Receiver in the XMB10
Install the receiver as follows:
IMPORTANT: Make sure boom box power is off before
installing and removing the Xpress
Receiver.
a. Press the EJECT button at the top of the XMB10; the
spring-loaded mounting plate will tilt forward.
2. Cabling Interconnections
You can begin to enjoy Xpress XM ® Satellite Radio
as soon as the Receiver and Boom Box Kit installation
are complete. Set up your Audiovox XMB10 by following
the interconnect diagram.
NOTE: The batteries are bypassed automatically
whenever the supplied AC Adapter is
plugged into the DC 12V jack on the back
panel.
1. Battery Installation
Your Boom Box can operate independently of AC
power by installing 8 C-Cell batteries as follows:
BATTERY
COMPARTMENT
COVER
BOTTOM OF
BOOM BOX
COVER LATCHES
MOUNTING
PLATE
DETENT
MOUNTING
PLATE
RECEIVER
COMPARTMENT
CONNECTOR
GUIDE PIN
EJECT BUTTON
Xpress
RECEIVER
CONNECTOR
BATTERY
COMPARTMENT
(COVER REMOVED)
NEGATIVE
POSITIVE NEGATIVE
POSITIVE