Audiovox XMB10 - Manual (Page 10)

128-7546
10 of 16
-10-
To mount the antenna:
a. Plug the antenna into the ANT connector on the
back of the XMB10.
b. Leave the antenna in place on the Boom Box,
or remove the antenna from its mount, uncoil
the antenna cable, and place it at the preferred
location inside or outside the home. If the Xpress
Receiver display indicates “NO SIGNAL,” the
antenna needs to be repositioned. In addition,
even if you are receiving the XM signal, it is
recommended that you optimize the position of
your XM Antenna as described in this section
enabling you toreceive the strongest possible
signal and consistent, mute-free reception.
c. Your Xpress Receiver display has two different
signal-strengthindicators which will help you
optimize the antenna’s position: The first is a
basic signal strength indicator visible at the upper
right corner of the display screen during normal
listening. It has from zero to three vertical bars;
three bars represent the strongest signal. The
other is a higher-resolution signal-strength
indicator screen showing Terrestrial and
Satellite indications which allow you to opti-
mally aim your XM Antenna. To access and
use this screen, refer to the Xpress XM Satellite
Radio Receiver User Guide (128-7454).
7. Positioning the XM Antenna
The antenna supplied with the XMB10 is a high-gain
type that can receive XM’s signal from one of XM’s
satellites and/or, depending on where you live, XM’s
terrestrial repeaters. It is recommended that the
antenna be positioned near a south-facing window or
outdoors with a clear view of the southeastern sky in
order to receive the satellite signal. In some cases, it
will be possible to receive XM’s signal through
standard home walls or a roof. To position your
antenna, first set up the Boom Box as described
earlier in this user guide. Next, position the antenna
until you receive the strongest possible satellite sig-
nal. If the satellite signal is not available, you can op-
timize it for a terrestrial signal (where available).