I-View ATX-100V/ARX-100V/ARX-400V Multi-videos Transmission System - Manual (Page 4)

Troubleshooting:
Events Problem verification and solution
Can not power on 1.
Please test with other device to verify that the AC outlet or power source (e.g. UPS) is supplying power
and the voltage is between AC100V to AC240V (50Hz / 60Hz)
2.
Please verify that the power adapter is connected properly and with a good solid grounding.
3. Please verify the connected power source is working fine and power on.
Ghosts, faint shadows 1.
Please verify that the using wire is “Un-shield Twister Pair” wire, and is connected properly.
2.
Please check if there is a “bridge tape” in the installation and remove it.
3.
Please verify that if the ground wire is connected properly.
4. Please check if there is a crosstalk in the installation.
Faint or blurry
picture
1.
Please verify that the using wire is “Un-shield Twister Pair”, and is connected properly.
2.
Please verify if the Un-shield Twister Pair is oxidized. If so, please replace a new one.
3.
Please verify end-to-end connectivity with an ohmmeter to check if the wire distance is over expected
(1.6Km for ARX-100V/ARX-400V connecting to ATX100V, 1Km for ARX-100V/ARX-400V
connecting to PTT-100V/130V (S)/120V. The testing result base on the Category 5 UTP cable and color
camera.)
4.
Please follow the “Video signal adjusters” to adjust the “Gain value dip switch”, “Impedance adjuster”
and “Bright/Sharp adjuster.
No video 1.
Please check if all devices are power on.
2.
Please test periphery connected device (e.g. camera, monitor and wire) separately to verify if it is
working fine.
Specification:
Model/ Item ARX-400V ARX-100V ATX-100V
Communication Type Receiver Transmitter
Port Number 4 1
Transmission Signal Video
Connector BNC, & RJ 45 BNC & Screw Terminal
Impedance BNC: 75Ω; Terminal Block: 100 Ω
Wire Cable Category 2 or better; Unshielded Twisted Pair 24-16 AWG (0.5-1.31mm)
Surge Suppression/ RF Noise Immunity /
Cross Talk Immunity/ Distance Equalization
Yes
Power request DC12V/300mA DC12V/100mA
Environmental Temperature: 0-50
℃ Humidity: 0 to 95% (non-condensing)
Dimension (W x H x L ) / Weight 215 x 55x 35 mm / 0.5Kg 97 x 60 x 35 mm / 0.2Kg
Customer Support:
Tel: 886-3-5103001 Fax: 886-3-5103002
Email: [email protected]