I-View ATX-100V/ARX-100V/ARX-400V Multi-videos Transmission System User Manual

Page 2

Front Panel

Rear Panel

Remote Terminal

UTP cable

ARX-400V/100V RJ45

ATX-100V

or PTT-120V

or PTT-130V

Video

ARX-400V Function Description:

1.) Surge ground: As for “S “ surge suppression port connects to earth-ground by shorter than 10 feet 16AWG or thicker cable.

2.) Front panel screws: The screws for fixing front panel and RMP-219 (19” rack mount panel)

3.) Power indicator: To indicate the status power-on or power-off of ARX-400V.

4.) Gain dip switches: According to the cable category and distance, user may need to adjust this switch to get optimum video picture.

5.) BNC ports: To connect with BNC connector of monitor or DVR.

6.) Bright/Sharp adjusters: To adjust video’s quality with a monitor for remote camera’s video signal.

7.) 8 pin RJ-45 connector: To connect to ATX-100V or PTT-100V(S) /130V(S) /120V by UTP wire of category 2 to 5 or better. Refer

to the pin assignment as below:

8.) Impedance adjuster: To increase and restore original video signal.

9.) Power jack: Plug DC12V power supply.

Product Application Diagram and Installations

Using the ARX-100V to connect with ATX-100V at both Monitor and camera ends.

Using the ARX-100V to connect with PTT-100V(S) /130V(S)/120V at both Monitor and camera ends.

Using the ARX-400V to connect with PTT-100V/130V(S)/120V and ATX-100V devices at both DVR control and cameras ends