Dual Electronics XDM6400 - Manual (Page 5)

Faceplate Removal
Semi-Permanent
Faceplate Installation
Power On/Off
Mode
Auxiliary Input
Volume
Programmable
Turn-On Volume
Mute
Preset EQ Curves
Reset
Display
General Operation
XDM6400 OPERATION
5
Press RELEASE and pull away from the left side to remove.
To re-install, insert right side of faceplate first then push
left side to secure.
Remove trim ring and install supplied #1 x 7/” Phillips
head screw through left side of mounting frame into faceplate.
Press POWER or any other button (except eject) to turn the
unit on. Inserting a disc will turn the unit on automatically.
Press POWER to turn the unit off.
Press MODE to select between AM/FM, CD player, auxiliary
input, USB and Bluetooth (optional). Modes of operation are
indicated in the display.
NOTE: CD, USB and Bluetooth modes will not appear unless
a CD is inserted, a USB device (sold separately) is connected
or BTM60 (Bluetooth module - sold separately) is attached.
Insert .5 mm plug to connect your portable audio device.
Adjust volume using rotary encoder (00-46).
Press and hold POWER for seconds to program currently
selected volume level. "P-VOL" and the current volume level
will momentarily appear in the display.
Press MUTE to silence the audio. “MUTE” will flash in the
display. Press MUTE again to cancel.
Press EQ to select between POP, JAZZ, CLASSIC, BEAT,
ROCK and OFF (default) equalization curves. Any adjustment
to the Bass or Treble settings automatically cancels the
current EQ curve (if one is selected).
Press to RESET the unit upon initial installation or if
abnormal operation occurs. The reset button is located
behind the faceplate.
Press DISP to select between clock and different types of
information, such as radio frequency, CD track/elapsed time,
or MP/WMA/USB song information.