Veris Technologies MSP EC and pH (1997-2008 CF card drive 1.10M) - Operating Instructions User Manual

Page 13

Veris Technologies

Pub. #OM MSP03-1

Signal Cable
Attach the signal cable to the quick connect coupler at front of frame, and to Signal Port on back of
instrument

Adjustable Wing Extensions (XA option)
The MSP3150 with XA (Extendable Array): This option allows the re-positioning of the electrodes to
fit various bed and crop configurations. Adjustment is made by loosening the jam nuts and set
screws located on the lower front of each side of the toolbar, adjusting the toolbar wing extensions,
and re-tightening the set screws. Veris suggests setting the toolbars at either the maximum or
minimum setting, not at a point in between. A limiter bolt determines full extension, so there should be
no danger of extending to the point at which the outside coulters disconnect from the main frame.
Important

– do not attempt to combine maps in which two different investigative depths are used.

• Pinch point hazard: to prevent injury, stand clear when raising or lowering any part of the Veris
MSP. Disengage automatic cycling function before working around unit.
• Install all transport locks before transporting or working underneath.

Collecting Soil EC Data
If unit is equipped with pH Module, and you are not collecting pH data, remove sampler shank and
raise row cleaner and covering disks.

set screws and jam
nuts