Bosch AHS 45-16 - Manual (Page 10)

10 | English
F 016 L70 775 | (25.4.12) Bosch Power Tools
Children should be supervised to ensure that they do not
play with the appliance.
f When working with the machine, always hold it firmly
with both hands and provide for a secure stance. The
power tool is guided more secure with both hands.
f Wait until the machine has come to a standstill before
placing it down.
f Other persons and animals should remain at a distance of
3 metres or more when the machine is being used. The op-
erator is responsible for third persons in the working area.
f Never grasp the blade of the hedgecutter.
f Children or persons unfamiliar with these instructions
must not operate the hedgecutter. Local regulations may
restrict the age of the operator.
f Never cut a hedge while people, especially children or
pets, are nearby.
f The operator or user is responsible for accidents or haz-
ards occurring to other people or their property.
f Do not operate the hedgecutter when barefoot or wearing
open sandals, always wear substantial footwear and long
trousers. The use of sturdy gloves, non-skid footwear and
safety glasses is recommended. Do not wear loose cloth-
ing or jewellery which can be caught in moving parts.
f Thoroughly inspect the area where the hedgecutter is to be
used and remove all wires and other foreign objects.
f Prior to operation, check cutter blades, blade bolts and
cutter assembly for wear or damage. Do not operate with a
damaged or excessively worn cutting device.
f Check cable for damage before starting work and replace if
necessary. Keep cable away from heat, oil and sharp edg-
es.
f Know how to stop the hedgecutter quickly in an emergen-
cy.
f Cut a hedge only in daylight or in good artificial light.
f Never operate the hedgecutter with defective guards or
without the guard in place.
f Always ensure all handles and guards supplied are fitted
when using the hedgecutter. Never attempt to use an in-
complete hedgecutter or one with an unauthorised modifi-
cation.
f Never hold the hedgecutter by the guard.
f While operating the hedgecutter always be sure of a safe
and secure operating position at all times, especially when
using steps or a ladder.
f Always be aware of your surroundings and stay alert for
possible hazards that you may not hear whilst operating
the hedgecutter.
Remove the plug from the socket:
– before checking, clearing a blockage or working on the
hedgecutter.
– after striking a foreign object, inspect the hedgecutter for
damage and make repairs as necessary.
– if the hedgecutter starts to vibrate abnormally check im-
mediately.
f Keep all nuts, bolts and screws tight to ensure that the
hedgecutter is always in a safe working condition.
f The hedgecutter should be stored in a dry, high or locked
up place out of the reach of children.
f Replace worn or damaged parts for safety.
f Do not attempt to repair the machine unless you are quali-
fied to do so.
f Ensure replacement parts fitted are Bosch approved.
Electrical Safety
f Warning! Switch off, remove plug from mains before
adjusting, cleaning or if cable is cut, damaged or entan-
gled.
f The blades continue to move for a few seconds after
the hedgecutter is switched off. Caution! Do not touch
the moving blades.
Your machine is double insulated for safety and requires no
earth connection. The operating voltage is 230 V AC, 50 Hz
(for non-EU countries 220 V, 240 V as applicable). Only use
approved extension cables. Contact your Bosch Service Cen-
tre for details.
Extension cords/leads should only be used if they comply
with H05VV-F or H05RN-F types.
It is recommended for increased electrical safety to use a Re-
sidual Current Device (RCD) with a tripping current of not
more than 30 mA. Always check your RCD every time you use
it.
For products not sold in GB:
WARNING: For your safety, it is required that the plug at-
tached to the machine is connected with the extension cord.
The coupling of the extension cord must be protected against
splash water, be made of rubber or coated with rubber. The
extension cord must be used with a cable strain relief.
The connection lead must be inspected for signs of damage at
regular intervals and may only be used if in perfect condition.
If the supply cord is damaged, it must be replaced by a Bosch
Service Centre.
Products sold in GB only: Your product is fitted with an
BS 1363/A approved electric plug with internal fuse (ASTA
approved to BS 1362).
If the plug is not suitable for your socket outlets, it should be
cut off and an appropriate plug fitted in its place by an author-
ised customer service agent. The replacement plug should
have the same fuse rating as the original plug.
The severed plug must be disposed of to avoid a possible
shock hazard and should never be inserted into a mains sock-
et elsewhere.
Products sold in AUS and NZ only: Use a residual current de-
vice (RCD) with a rated residual current of 30 mA or less.
Maintenance
f Always wear gardening gloves when handling or working
near the sharp blades.
f Examine the machine and replace worn or damaged parts
for safety.
f Always lubricate the cutting blade with protective spray
before storage.
OBJ_BUCH-1297-004.book Page 10 Wednesday, April 25, 2012 11:10 AM