Acme BH04 - Manual (Page 2)

2
GB
Overview
The headset contains the following parts as shown
in the figure:
(1) Answer/end key.
(2) Led Indicator (red/blue)
(3) Volume up (r) and volume down (s)
(4) Microphone
(5) Earphone
(6) Charger socket
Before you can start using the headset, you must
charge the battery and pair the headset with a
compatible phone.
Note: Parts of the headset are magnetic. Metallic
materials may be attracted to the headset. Do not place credit cards or other magnetic
storage media near the headset, because information stored on them may be erased.
Charge the battery
This device has an internal, rechargeable battery. It connects the charger cable to the
headset.
• Connect the charger to a wall outlet. The red indicator light is displayed during
charging. If charging does not start, disconnect the charger, plug it again, and retry.
Charging the battery fully may take up to 2 hours.
• When the battery is fully charged, the red indicator light will turn off. Disconnect the
charger from the wall outlet and the headset.
The fully charged battery has power for up to 4 hours of talk-time or up to 90 hours of
standby time. However, the talk and standby times may vary when used with different
mobile phones, products that use a Bluetooth connection, usage settings, usage styles,
and environments.
When the battery is running out of power, the red indicator light starts to flash.
Switch the headset on or off
To switch on, press and hold the Answer/end key for 4 seconds. The blue indicator light
starts to flash.
To switch off, press and hold the power key for 4 seconds until the red indicator light is
displayed briefly.