Shure BLX4R - Manual (Page 10)

group
(A-Y)
channel
group
group channel
channel
group
group
group channel
10
Single System Set Up
Before you begin, turn off all transmitters and turn on any equipment (other
microphones or personal monitoring systems) that could cause interference
during the performance.
1. Press and release the group button on the receiver.
The receiver scans for the clearest group and channel.
Note: If you want to stop the scan, push the group button again.
2. Turn on transmitter and change the group and channel to match the re-
ceiver (See Setting Transmitter Group and Channel).
Once the system is set up, perform an audio check and adjust the gain if necessary.
Setting Transmitter Group and Channel
Transmitter group and channel must be manually set to match the receiver.
Group (letter)
1. Press and release the group button on the transmitter to acti-
vate the display. Press the group button again and the display
flashes.
2. While the display is flashing, press the group button again to ad-
vance to the desired group setting.
Channel (number)
If channel needs to be changed, follow the same procedure using the channel
button instead of the group button.
Note:
• When the group and channel correctly match the receiver, the RF bars
and battery LED on the receiver illuminate.
• After manual setup, the transmitter alternately displays the group and
channel setting for about two seconds.