beautypg.com

Scooter care and storage, Care – Yamaha YJ125T User Manual

Page 62

background image

7-1

1

2

3

4

5

6

7

8

9

SCOOTER CARE AND STORAGE

EAU26090

Care

While the open design of a scooter re-
veals the attractiveness of the technol-
ogy, it also makes it more vulnerable.
Rust and corrosion can develop even if
high-quality components are used. A
rusty exhaust pipe may go unnoticed on
a car, however, it detracts from the over-
all appearance of a scooter. Frequent and
proper care does not only comply with
the terms of the warranty, but it will also
keep your scooter looking good, extend
its life and optimize its performance.

Before cleaning

1. Cover the muffler outlet with a plas-

tic bag after the engine has cooled
down.

2. Make sure that all caps and cov-

ers as well as all electrical couplers
and connectors, including the spark
plug cap, are tightly installed.

3. Remove extremely stubborn dirt,

like oil burnt onto the crankcase,
with a degreasing agent and a
brush, but never apply such prod-
ucts onto seals, gaskets and wheel
axles. Always rinse the dirt and
degreaser off with water.

Cleaning

ECA10780

c

C

8

8

8

8

8 Avoid using strong acidic wheel

cleaners, especially on spoked
wheels. If such products are used
on hard-to-remove dirt, do not
leave the cleaner on the affected
area any longer than instructed.
Also, thoroughly rinse the area
off with water, immediately dry
it, and then apply a corrosion
protection spray.

8

8

8

8

8 Improper cleaning can damage

windshields, cowlings, panels
and other plastic parts. Use only
a soft, clean cloth or sponge with
mild detergent and water to clean
plastic.

8

8

8

8

8 Do not use any harsh chemical

products on plastic parts. Be sure
to avoid using cloths or sponges
which have been in contact with
strong or abrasive cleaning prod-
ucts, solvent or thinner, fuel
(gasoline), rust removers or in-
hibitors, brake fluid, antifreeze or
electrolyte.

8

8

8

8

8 Do not use high-pressure wash-

ers or steam-jet cleaners since
they cause water seepage and
deterioration in the following ar-
eas: seals (of wheel and
swingarm bearings, fork and
brakes), electric components
(couplers, connectors, instru-
ments, switches and lights),
breather hoses and vents.

8

8

8

8

8 For scooters equipped with a

windshield: Do not use strong
cleaners or hard sponges as they
will cause dulling or scratching.
Some cleaning compounds for
plastic may leave scratches on
the windshield. Test the product
on a small hidden part of the
windshield to make sure that it
does not leave any marks. If the
windshield is scratched, use a
quality plastic polishing com-
pound after washing.

After normal use
Remove dirt with warm water, a mild
detergent, and a soft, clean sponge, and

SCOOTER CARE AND STORAGE

5YR-F8199-11ch7.pmd

2004/06/11, 14:13

1