7 security settings in windows vista, A. see, Section – ZyXEL Communications SMG-700 User Manual
Page 61: For information on
Chapter 4 Station Mode
NWD-270N User’s Guide
61
4.6.3 WPS: PIN - Use the PIN from the AP or Wireless Router
This screen allows you to use the WPS Personal Identification Number mode, by entering the
PIN from another WPS-enabled device into the NWD-270N’s utility. See
for more information. Select WPS and PIN - Use the PIN from the AP or Wireless
Router in the Adapter screen. The following screen displays.
Figure 48 WPS: PIN - Use the PIN from the AP or Wireless Router
The following table describes the labels in this screen.
4.7 Security Settings in Windows Vista
When you use the NWD-270N in Windows Vista, the procedure for setting up WPA, WPA2
and 802.1x security settings is different from that of other operating systems (other security
types are not affected).
The procedures for setting up WPA, WPA2 or 802.1x in Vista are the same. However, the
procedure differs depending on whether you use PEAP (Protected Extensible Authentication
Protocol) or TLS (Transport Layer Security) encryption. Consult your network administrator
if you are unsure which type of encryption to use.
See
to use PEAP, or see
to use TLS.
"
TTLS (Tunneled TLS) is not available when using Windows Vista, at the time
of writing.
Table 19 WPS: PIN - Use the PIN from the AP or Wireless Router
LABEL
DESCRIPTION
AP or Router’s PIN
Enter the PIN from your AP or wireless router in this field before you
click Start.
Start
Click this to start WPS. You must start WPS on the other WPS-
enabled device within two minutes.