Yamaha LF225 - Manual (Page 28)

Basic components
22
NOTE:
The speedometer displays km/h, mph, or
knots, according to operator preference. Se-
lect the desired unit of measurement by set-
ting the selector switch on the back of the
gauge. See the illustration for settings.
EMU26620
Trim meter (digital type)
This meter shows the trim angle of your out-
board motor.
NOTE:
● Memorize the trim angles that work best for
your boat under different conditions. Adjust
the trim angle to the desired using the pow-
er trim and tilt switch.
● If the trim angle of your motor exceeds the
trim operating range, the top segment on
the trim meter display will blink.
EMU26650
Hour meter (digital type)
This meter shows the number of hours the en-
gine has been run. It can be set to show the
total number of hours or the number of hours
for the current trip. The display can also be
turned on and off.
● Changing the display format
Pressing the “
” (mode) button chang-
es the display format in the following pat-
tern:
Total hours
→Trip hours→Display off
● Resetting the trip hours
Simultaneously pressing the “
” (set) and
“ ” (mode) buttons for more than 1 sec-
ond while the trip hours are displayed re-
sets the trip counter to 0 (zero).
NOTE:
The total number of hours the engine has
been run cannot be reset.
1. Cap
2. Selector switch (for speed unit)
3. Selector switch (for fuel sensor)
ZMU01740
ZMU01741
U69J17E0.book Page 22 Tuesday, March 7, 2006 10:00 AM