Yamaha YST-SW1500 - Manual (Page 8)

E- 4
OUTPUT
TO SPEAKERS
INPUT
1
FROM AMPLIFIER
100Hz 80Hz
/MONO
NORMAL
INPUT
2
INPUT
3
LFE
GND
H.P.F.OUTPUT
SPLIT SUBWOOFER
SUBWOOFER
( LOW PASS)
AC IN
ON POWER
OFF
HIGH LOW OFF
AUTO STANDBY
OUTPUT INPUT
REMOTE OUTPUT TO SPEAKERS
INPUT 1 FROM AMPLIFIER
100Hz 80Hz /MONO NORMAL
INPUT 2 INPUT 3
LFE
GND
H.P.F.OUTPUT
CONNECTIONS
Caution: Plug in the subwoofer and other audio/video components after all connections are
completed.
● All connections must be correct, that is to say L (left) to L, R (right) to R, “+” to “+” and “–” to “–”. Also refer to the owner’s
manual for each of your components.
● The subwoofer can be connected to either the line output (pin jack) terminals or the speaker output terminals of the amplifier.
Choose one of the ways shown in this section that is more suitable for your audio system. Also, refer to the owner’s manual
of your component to be connected to the subwoofer.
Basically, connect the subwoofer to the line output (pin jack) terminal(s) of the amplifier. (Refer to pages 4 and 5 for details.)
If your amplifier does not have any line output terminal, connect the subwoofer to the speaker output terminals of the
amplifier. (Refer to pages 6 and 7 for details.)
Subwoofer
Amplifier
● To connect with a YAMAHA DSP amplifier (or AV
receiver), connect the SUBWOOFER (or LOW PASS etc.)
terminal on the rear of the DSP amplifier (or AV receiver)
to the L/MONO INPUT2 terminal of the subwoofer.
Connect the main speakers to the speaker output terminals of the amplifier.
● When connecting the subwoofer to the SPLIT
SUBWOOFER terminals on the rear of the DSP amplifier,
be sure to connect the L/MONO INPUT2 terminal to the
“L” side and the R INPUT2 terminal to the “R” side of the
SPLIT SUBWOOFER terminals.
Audio pin cable
(not included)
Connecting to line output (pin jack) terminals of the amplifier
Ⅵ Using one subwoofer
Left main speaker Right main speaker
Mono pin cable
(not included)
2-SW1500(UB) (02.9.2)a 02.9.2, 6:46 PM 4