Yamaha YST-SW1500 - Manual (Page 15)

English
E-
11
Battery replacement
If you find that the remote control must be used closer to
the main unit, the batteries are weak. Replace both
batteries with new ones.
Notes
● Use only AA, R6, UM-3 batteries for replacement.
● Be sure the polarities are correct. (See the illustration
inside the battery compartment.)
● Remove the batteries if the remote control will not be
used for an extended period of time.
● If batteries leak, dispose of them immediately. Avoid
touching the leaked material or letting it come in contact
with clothing, etc. Clean the battery compartment
thoroughly before installing new batteries.
Notes
● There should be no large obstacles between the remote
control and the main unit.
● If the remote control sensor is directly illuminated by
strong lighting (especially an inverter type of fluorescent
lamp etc.), it might cause the remote control not to work
correctly. In this case, reposition the main unit to avoid
direct lighting.
3
1
2
Battery installation Remote control operation range
30°
30°
Remote control
sensor
Within approximately
6 m (20 feet)
NOTES ABOUT THE REMOTE CONTROL
Connecting the AC power cable
< U.S.A., Canada, Europe and Korean models >
When all connections are completed, plug the included
power cable into the AC IN socket of the subwoofer, and
then plug in the power cable to the wall outlet.
Notes
● Never connect any power cable other than the included
one to the subwoofer. Otherwise, it may result in causing
fire or an electrical shock.
● Do not connect the included power cable to any other unit
than this subwoofer.
< U.K. and Australia models >
Plug in the subwoofer to the wall outlet.
AC IN
ON
POWER
OFF
AC IN
ON
POWER
OFF
(U.S.A. model)
(U.K. model)
To AC outlet
To AC outlet
2-SW1500(UB) (02.9.2)a 02.9.2, 6:46 PM 11