Dvd player (dvd-e810) – Yamaha E810 User Manual
Page 65
61
En
Troubleshooting
Eng
lish
AD
DITIONAL
INFO
RMA
T
ION
DVD player (DVD-E810)
Problem
Cause
Remedy
See
page
Power turns on but
immediately shuts off.
The power cable is not connected or the
plug is not completely inserted.
Connect the power cable firmly.
Power immediately
shuts off during
playback.
Auto-standby function of the receiver
works when the receiver can not receive
the playing signal transmitted from the
DVD player with the system control cable
for 30 minutes.
Check the connection of the system control cable
between the receiver and the DVD player.
The TV (monitor)
does not show the
picture properly.
The component video signal output setting
may not match the video connection.
Set “COMPONENT” of the DVD player to match the
connection method.
The color system setting of the DVD
player may not match the specification of
your TV.
Check that the color system of your TV, and then set
“TV TYPE”of the DVD player to match it.
The progressive scan mode may be used
with a TV that does not support it.
Set “PROGRESSIVE” to “OFF”.
The disc being played back may not be
compatible with the DVD player.
Check that the disc is compatible with the DVD
player.
Occasionally, a small amount of picture
distortion may appear depending on the
disc being played back. This is not a
malfunction.
The screen size of the
TV or monitor looks
strange (the image is
distorted or the
subtitle is missing).
The TV size setting of the DVD player to
match the connection method.
Set “TV DISPLAY” of the DVD player to match your
TV, or check the screen size setting of your TV.
When the progressibe scan mode is
activated, image with a 4:3 aspect ratio are
played back on a 16:9 wide television
screen.
Set “TV DISPLAY” of the DVD player to adjust the
screen size. If you cannot adjust it, set
“PROGRESSIVE” to “OFF”.
No sound or distorted
sound
The sampling rate of a MP3 or WMA file
may not be compatible with the DVD
player.
Check the sampling rate and bit rate of an MP3 or
WMA file are compatible with the DVD player.
No audio at digital
output
Incorrect digital cable connections.
Connect the digital cables properly.
The disc being played back may not be
compatible with the DVD player.
Check that the disc is compatible with the DVD
player.
The digital output settings of the DVD
player may not be set properly.
Set “DIGITAL OUTPUT” of the DVD player
according to your external audio equipment
connections.