Yamaha E810 - Manual (Page 16)

CONNECTING THE SYSTEM
12
En
Make sure you read the following procedure and notes carefully before connecting the system. For information on the
speakers (NX-E800), refer to the owner’s manual supplied with it.
Do not connect the power cable of the receiver, DVD player, or other components to the wall outlet until all cable connections are
completed.
1 Connect the DVD/CD (L/R) jacks of the receiver to the AUDIO OUT (L/R) jacks of the DVD player using the
supplied audio pin cable.
2 Connect the system connector (TO DVD-E810) jack of the receiver to the system connector (TO RX-E810) jack of
the DVD player using the supplied system control cable.
3 Connect the speaker terminals (L) of the receiver to the speaker terminals of the left speaker and the speaker terminals
(R) of the receiver to the speaker terminals of the right speaker using the speaker cables supplied with the speaker set
(NX-E800). See page 13 for details.
y
• The system control connection is used to synchronize the specific operations between the receiver and the DVD player.
• If you want to connect an amplifier with a digital input instead of the RX-E810, use the DIGITAL OUT (COAXIAL or OPTICAL)
jacks of the DVD player and configure the “DIGITAL OUTPUT” setting in the setup menu (see page 52).
Connecting the System
Note
L
R
AV
AUDIO
OUT
DIGITAL OUT
COAXIAL
COMPONENT
S VIDEO VIDEO P B
P R Y
OPTICAL
VIDEO OUT
MAINS
TO RX-E810
L R
L R
MAINS
SPEAKERS
DOCK
DVD/CD
TAPE/MD
AUX
OUT
IN
FM
GND
AM
ANTENNA
75
UNBAL.
TO DVD-E810 SUBWOOFER
OUT
100W MAX. TOTAL
AC OUTLETS
SWITCHED
6 MIN / SPEAKER
1
3 3
2
Receiver (RX-E810)
(Europe model)
DVD player (DVD-E810)
Left speaker
(NX-E800)
Right speaker
(NX-E800)