Yamaha FJR1300 - Manual (Page 64)

PERIODIC MAINTENANCE AND MINOR REPAIR
6-13
6
5. Install and tighten the filler bolt.
6. Check the final gear case for oil
leakage. If oil is leaking, check for
the cause.
EAU04044
Checking the coolant level
The coolant level should be checked as
follows before each ride. In addition,
the coolant must be changed at the in-
tervals specified in the periodic mainte-
nance and lubrication chart.
1. Place the motorcycle on a level
surface and hold it in an upright
position.
NOTE:
_
● The coolant level must be checked
on a cold engine since the level
varies with engine temperature.
● Make sure that the motorcycle is
positioned straight up when
checking the coolant level. A slight
tilt to the side can result in a false
reading.
_
2. Check the coolant level in the
coolant reservoir.
NOTE:
_
The coolant should be between the
minimum and maximum level marks.
_
Recommended final gear oil:
Shaft drive gear oil
(Part No.: 9079E-SH001-00)
Oil quantity:
0.2 L
1. Maximum level mark
2. Minimum level mark
E_5jw.book Page 13 Friday, March 30, 2001 2:14 PM