Yamaha FJR1300 - Manual (Page 25)

INSTRUMENT AND CONTROL FUNCTIONS
3-4
3
● a selfdiagnosis device
● a clock
Odometer and tripmeter modes
Pushing the “SELECT” button switches
the display between the odometer
mode “ODO” and the tripmeter modes
“TRIP” in the following order:
ODO
→ TRIP (top) → TRIP (bottom)
→ ODO
When approximately 5 L of fuel re-
mains in the fuel tank, the display will
automatically change to the fuel re-
serve tripmeter mode “TRIP F” and
start counting the distance traveled
from that point. In that case, pushing
the “SELECT” button switches the dis-
play between the various tripmeter and
odometer modes in the following order:
TRIP F
→ TRIP (top) → TRIP (bottom)
→ ODO → TRIP F
To reset a tripmeter, select it by push-
ing the “SELECT” button, and then
push the “RESET” button for at least
one second. If you do not reset the fuel
reserve tripmeter manually, it will reset
itself automatically and the display will
return to the prior mode after refueling
and traveling 5 km.
Self-diagnosis device
This model is equipped with a self-di-
agnosis device for various electrical cir-
cuits.
If any of those circuits are defective,
the clock will indicate a two-digit error
code (e.g., 11, 12, 13).
If the clock indicates such an error
code, note the code number, and then
have a Yamaha dealer check the
motorcycle.
ECA00100
CAUTION:
_
If the clock indicates an error code,
the motorcycle should be checked
as soon as possible in order to
avoid engine damage.
_
Clock mode
To set the clock:
1. Push the “SELECT” button and
“RESET” button together for at
least two seconds.
2. When the hour digits start flashing,
push the “RESET” button to set
the hours.
3. Push the “SELECT” button, and
the minute digits will start flashing.
4. Push the “RESET” button to set
the minutes.
5. Push the “SELECT” button and
then release it to start the clock.
E_5jw.book Page 4 Friday, March 30, 2001 2:14 PM