Zebra Technologies Zebra S Series 105SL - Manual (Page 110)

86 105SL User Guide 6/4/2004 11342L Rev. 8
Troubleshooting
Printer Diagnostics
CANCEL Self Test
The CANCEL self test prints a configuration label, which tells you the current settings for the
printer.
The configuration may be changed either temporarily (for specific label formats or ribbon and
label stock) or permanently (by saving the new parameters in memory). Saving new
parameters occurs whenever a calibration procedure is performed. Refer to
Basic Printer
Configuration on page 45 for further information about the configuration procedure.
Additional Power-Up Self Tests are also performed during the POST for this test.
To perform the CANCEL Self Test, complete these steps:
1. Turn Off (O) the printer.
2. Press and hold CANCEL while turning the power On (I). Hold CANCEL until the DATA
light turns off.
A printer configuration label prints (
Figure 46 ).
Figure 46 • Configuration Label